6.2.12 How to Replace the X-motor
The CE5000-40 and the CE5000-60 models use the same X-motor.
The CE5000-120/120AP model uses a different X-motor from the CE5000-40 and the CE5000-60 models.
How to detach the X-motor
(1) Detach the left side cover (see Subsection 6.1.2).
(2) Detach the front guide (see Subsection 6.1.5 or 6.1.6).
(2) Detach the rear guide (see Subsection 6.1.7).
(3) Loosen the two M3L4WP set screws holding the X-motor pulley then detach the X-motor pulley.
M3L6 binding head screw
(4) Remove the three M3L6 binding head screws holding the X-motor then detach the X-motor.
(5) Disconnect the X-motor cable from its connector(s) on the main board.
CE5000-40/60: ............. Disconnect the encoder cable from the motor and disconnect the motor cable
CE5000-120/120AP: .... Disconnect the cables from connector J1102 and J1104 on the X-motor relay
(6) Remove the wiring harness tie-wrap holding the X-motor harness and detach the X-motor.
CE5000-UM-251-9370
from the relay connector.
board.
6. DISASSEMBLY AND REASSEMBLY
M3L4WP set screw
6-26