Sensor (Input) Static Jam Service Check - Lexmark M5150 Service Manual

Error code Description
200.33 Printhead was not ready for page when
sensor (input) was reached.
200.34 Short media detected.
200.35 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 3)
200.45 Media reached the sensor (input), but did not
clear it within the specified time. (Media
source = Tray 4)

Sensor (input) static jam service check

Action
Step 1
Check the media path for partially fed or jammed media.
Is the media path free from partially fed or jammed media?
Step 2
Check the sensor (input) for proper operation.
a
Enter the diagnostic mode.
b
Select Base sensor test.
c
Observe the line item input.
Does the display on the operator panel change every time the sensing
area of the above sensor is interrupted or blocked?
Step 3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Step 4
Perform a print test.
Does the problem remain?
Action
Go to "Printhead motor control jam service check" on
page 76.
Go to "Sensor (input) miscellaneous jam 3 service check" on
page 77.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Go to "Sensor (input) late-leaving or did-not-clear jam service
check" on page 74.
Yes
Go to step 2.
Go to
Replace the Sensor
(input). See
(input) removal" on
page
Go to step 4.
Contact the next
highest level of tech
support.
Diagnostic information
70
No
Remove any pre-
staged or jammed
media.
step 4. Go to step 3.
Reseat the connection.
"Sensor
Go to step 4.
407.
Problem resolved.
4063