Processor; Security Reset Jumper - Lexmark M5150 Service Manual

–
Altitude: 9,500 ft. (0 to 2896 meters)
–
Atmospheric pressure: 74.6 kPa
•
Power off
– Temperature: 50 to 110° F (10 to 43.3° C)
–
Relative humidity: 8 to 80%
–
Maximum wet bulb temperature: 80.1° F (26.7° C)
– Altitude: 9,500 ft. (0 to 2896 meters)
–
Atmospheric pressure: 74.6 kPa
•
Ambient operating environment*
– Temperature: 60 to 90° F (15.6 to 32.2° C)
–
Relative humidity: 8 to 80%
•
Storage and shipping (packaged printer) with or without print cartridge
Temperature: -40 to 110° F (-40 to 43.3° C)
*In some cases, performance specifications (such as paper OCF, EP cartridge usage) are measured at an ambient
condition.

Processor

800 MHz, dual core

Security reset jumper

The Security Reset Jumper is available on all high-end printer and MFP models.
Each device contains a hardware jumper with which an administrator can:
•
Erase all security templates, building blocks, and access controls that a user has defined (i.e. the factory default
configuration); or
• Force the value of each function access control to "No Security" (all security templates and building blocks are
preserved but not applied to any function).
Note: If the "Enable Audit " setting in the Security Audit Log section of the "Security Menu " is activated, the device
logs a message each time that the jumper is used.
A small lock icon identifies the jumper's position on the RIP card. Also, to make it easier to separate the small yellow
plastic jumper from the 3-pin connector, a looped handle is attached to the top of the small yellow jumper that covers
the 3-pin connector.
An administrator controls how a jumper reset affects a device by configuring the jumper-related setting on the Security
Web page.
Note: Administrators can discourage tampering with the jumper by securing the entire RIP card cage (of which the
jumper is a part) with a Kensington lock. Alternatively, to completely negate the effects of a jumper reset, an
administrator can select the No Effect value for the jumper-related setting on the Security Web page or in the
Security Reset Jumper setting in the Security Menu.
Appendix A: Printer specifications
883
4063