Maintenance Kit Very Low, [X] Estimated Pages Remain [80.Xy]; Memory Full [38]; Network [X] Software Error [54]; Non-Lexmark [Supply Type], See User's Guide [33.Xy] - Lexmark M5150 Service Manual

If necessary, select Continue to clear the message and continue printing. For non‑touch‑screen printer models,
press to confirm.

Maintenance kit very low, [x] estimated pages remain [80.xy]

You may need to replace the maintenance kit very soon. For more information, visit the Lexmark support Web site at
http://support.lexmark.com
If necessary, select Continue on the printer control panel to clear the message and continue printing. For
non‑touch‑screen printer models, press

Memory full [38]

Try one or more of the following:
• From the printer control panel, select Cancel job to clear the message. For non‑touch‑screen printer models, press
to confirm.
•
Install additional printer memory.

Network [x] software error [54]

Try one or more of the following:
• From the printer control panel, select Continue to continue printing. For non‑touch‑screen printer models, press
to confirm.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at http://support.lexmark.com.
Non‑Lexmark [supply type], see User's Guide [33.xy]
Note: The supply type can be toner cartridge or imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Lexmark supplies and parts and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark
printer or associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts may not be covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer, press
and hold and the # button on the printer control panel simultaneously for 15 seconds.
For non‑touch‑screen printer models, press
clear the message and continue printing.
or contact customer support, and then report the message.
to confirm.
and
Diagnostic information
on the printer control panel simultaneously for 15 seconds to
222
4063