Media pusher assembly removal
1
Remove the stapler left cover. See
2
Disconnect the cable J17 from the controller PCBA.
3
Remove the three screws (A), and then remove the media pusher.
Stapler feed roll removal
Note: This is not a FRU.
1
Remove the stapler left cover. See
2
Remove the stapler right cover. See
3
Remove the stapler diverter plunger assembly. See
4
Remove the stapler drive gear assembly. See
"Stapler left cover removal" on page
"Stapler left cover removal" on page
"Stapler right cover removal" on page
"Stapler diverter plunger assembly removal" on page
"Stapler drive gear assembly removal" on page
Repair information
672
630.
A
630.
624.
4063
667.
668.