5
Disconnect the cable (B) from the sensor, and then release the latches securing the sensor to the frame.
6
Pull the sensor off the frame and remove.
Stapler tamper assembly removal
1
Remove the finisher left cover. See
2
Remove the finisher right cover. See
3
Remove the finisher top cover. See
4
Disconnect the tamper cables J2, J4, and J6 from the stapler controller PCBA.
"Staple, hole punch left cover removal" on page
"Staple, hole punch right cover removal" on page
"Staple, hole punch top cover removal" on page
Repair information
767
B
739.
741.
762.
4063