Staple, Hole Punch Latch Removal; Stapler Controller Pcba Removal; Staple, Hole Punch Left Cover Removal - Lexmark M5150 Service Manual

Staple, hole punch latch removal

1
Remove the finisher left cover or finisher right cover. See
"Staple, hole punch right cover removal" on page
2
Pull the latch off the finisher.
Note: The latch on the right side of the finisher can also be removed by the same manner.

Stapler controller PCBA removal

1
Remove the finisher left cover. See
2
Remove the three screws (A) from the controller PCBA.
3
Disconnect all connectors, and then remove the controller PCBA.
"Staple, hole punch left cover removal" on page 739
741.
"Staple, hole punch left cover removal" on page
Repair information
749
4063
739.
or