Lexmark M5150 Service Manual page 269

Error code Description
383.52 Staple finisher/offset stacker: Motor stop error—the
output option 3/finisher/offset stacker ejector motor
kept on running some time after the motor was
commanded to stop.
383.52 Staple, hole punch finisher: Motor stop error—the
output option 3/finisher/offset stacker ejector motor
kept on running some time after the motor was
commanded to stop.
383.54 Staple finisher/offset stacker: No encoder feedback
detected from the output option 3/finisher/offset
stacker main/interface motor.
383.54 Staple, hole punch finisher: No encoder feedback
detected from the output option 3/finisher/offset
stacker main/interface motor.
383.55 Staple finisher/offset stacker: Motor stop error—the
output option 3/finisher/offset stacker
main/interface motor kept on running some time
after the motor was commanded to stop.
383.55 Staple, hole punch finisher: Motor stop error—the
output option 3/finisher/offset stacker
main/interface motor kept on running some time
after the motor was commanded to stop.
383.56 Staple finisher/offset stacker: The output option
3/finisher/offset stacker main/interface motor went
over the normal speed
383.56 Staple, hole punch finisher: The output option
3/finisher/offset stacker main/interface motor went
over the normal speed
Action
Go to "Finisher ejector jam service check" on
page 165.
Go to "Finisher (HPU) ejector jam service check" on
page 179.
Go to "Finisher main motor jam service check" on
page 166.
Go to "Finisher (HPU) main motor jam service
check" on page
Go to "Finisher main motor jam service check" on
page 166.
Go to "Finisher (HPU) main motor jam service
check" on page
Go to "Finisher main motor jam service check" on
page 166.
Go to "Finisher (HPU) main motor jam service
check" on page
Diagnostic information
269
178.
178.
178.
4063