Sensor (Cartridge Door Interlock) Removal - Lexmark M5150 Service Manual

7
Lift the stapler carriage to access the screws securing the limit switch.
8
Remove the two screws (D) securing the limit switch.
9
Disconnect the cable J7 from the controller PCBA.
10
Route the cable off the stapler, and remove the stapler door close limit switch.
Note: Pay attention to the original routing of the cables.

Sensor (cartridge door interlock) removal

1
Remove the stapler right cover. See
2
Disconnect the cable (A) from the sensor.
"Stapler right cover removal" on page
Repair information
627
624.
4063