Alert Settings - Motorola CA50 Developer & User Manual

8 - 16 CA50/UCA Client & Server Developer & User Guide
Client Settings (Continued)
Table 8-8
Field
DND Timeout
WebService Response Timeout
WebService PopupTime
Logout Barcode
UCA Exit Barcode
Enable Notification
Notification On Active Call
Cache TimeToLive
Notification Msg Timeout
Press And Hold Time

Alert Settings

Use the Alert Settings section to configure various alerts on the device for various events. It defines the type of
indication to provide in terms of the following:
•
Tone played
•
Visible indicator (lighting up LED in different colors and/or blinking the LEDs)
•
Vibrate Indicator.
For example: The NotifCallActive setting controls the kind of alert provided when a notification is sent (during an
active call). This defines the kind of tone to play, whether the LED blinks or not, which LED blinks and how fast.
This also controls if the device vibrates and how fast.
Alert Settings
Figure 8-19
The amount of time in seconds that the UCA client application stays in Do not disturb
mode.
The amount of time a Web service call stays connected waiting for a response.
The number of seconds to wait for a response from the server before displaying a Waiting
for Server message.
Set the Logout Barcode value to allow the user to scan a bar code to logout. Set this value
to "" to disable log off by bar code scanning. Note that, when enabled, scanning a bar
code to log off works only when the user is logged in.
Set the UCA Exit Barcode value to allow the user to scan a bar code to exit the UCA client
application. Set this value to "" to disable exiting the UCA client application by bar code
scanning. Note that, when enabled, scanning a bar code to exit the UCA client application
works only when the user is logged in.
Checking this enables notifications, unchecking this disables notifications.
Check to enable notifications while on a phone call, uncheck to disable.
Ignored, currently not implemented.
The time in seconds for a notification message to display.
Ignored, currently not implemented.
Description