Step 4. Validate Successful Server Installation On Laptop; Step 5. Configure The Rf Hardware - Motorola CA50 Developer & User Manual

Step 4. Validate Successful Server Installation on Laptop

To verify the installation and configuration of the UCA server software follow the process documented in
Successful Server Installation and Proper Performance on page
use the default Web Console user login information:
• Default User ID: admin
• Password: admin
IMPORTANT Ensure to enter all settings called out on
IMPORTANT At the initial login to the Web Console (for details see

Step 5. Configure the RF Hardware

Configure the WS2000 and its AP using the settings listed in
WS2000 and AP Configuration
Table E-1
LAN Subnet 1
LAN Subnet 1 Assigned Ports
Subnet 1 DHCP Server
DHCP Range
WLAN 1 ESSID
WLAN 1 Security Authentication and Encryption
Access Ports 802.11 a/b/g Defaults Beacon Settings
Wireless QoS
IMPORTANT WS2000 firmware version 2.2.3 or higher is recommended.
Console administrator Username and Password:
•
Factory Default Web Console Username: admin
•
Factory Default Web Console Password: admin
It is strongly suggested that the default administrator Username and Password be changed after the
initial login.
Note that the Username and Password entered during the UCA server software installation process,
step on page 6-13
( ) are for SQL database access and should not be mistaken with the default
Web Console administrator Username and Password shown above.
Field
Self Contained Pre-Built Demo
6-45. When performing the validation process,
page 6-45
exactly as shown.
page 9-3
), it is required to use the default Web
Table E-1
Setting
192.168.0.1 <Default>
1 – 6 and WLAN1
On
192.168.0.100 to 192.168.0.150
UCA
Both Open
DTIM per BSSID to 2
Use Voice Prioritization for WLAN1 "Checked"
E - 5
Validate