Powering On The Ca50 - Pre-Deployment - Motorola CA50 Developer & User Manual

Powering On the CA50 - Pre-deployment

The CA50 device powers on when a charged battery is installed (see
charged battery was already installed and the device is put into sleep mode, press any key to wake the device.
NOTE If the device does not power on, the battery charge may be depleted. See
Upon initial use, first time out-of-box, the Motorola splash screen displays briefly and then the device boots up to
the CA Menu. For additional information about the CA Menu see
PL X.XX.XXX
CE X.XX.XX
PM XX.XX.X
Motorola Splash Screen and CA Menu.
Figure 3-6
NOTE Use Rapid Deployment bar codes to initially stage and deploy the CA50 by setting the wireless network
configuration and enter the UCA server IP address. For information about configuring the CA50 using
Rapid Deployment, see
CA Menu
Main
Rapid Deployment Rapid Deploy
Programs
Settings
System info
Chapter 12, Staging and Deploying CA50s
Getting Started 3 - 11
Inserting the Battery on page
Charging Batteries on page
CA Menu on page 3-12.
and Appendix F, Rapid
3-4). If a
3-8.
Deployment.