System Settings - Motorola CA50 Developer & User Manual

Table of Contents

Advertisement

6 - 48 CA50/UCA Client & Server Developer & User Guide

System Settings

Table 6-2
lists the system settings for CA50 Client/Server software. (See
additional information about System Settings and their values.)
NOTE To enter these settings into the Web Console see
System Settings
Table 6-2
Setting
Client.Backlight.Battery.Timeout
Client.Backlight.Level
Client.Desktop.Link.DefaultScan
Client.NewPhoneRegRetryCount
Client.PhoneRegRetryCount
Client.PhoneRegRetryInterval
Client.Phone.Ring
Client.Volume.Receiver
Client.Volume.Speaker
Phone.Call.UnicastPacketRate
Phone.Gateway.CallPark.ByGroup.Enable
Phone.Gateway.CallPark.Enable
Phone.Gateway.FAC.CallPark
Phone.Gateway.FAC.CallPick
Phone.Gateway.IPAddress
1
The Motorola UCA Maintenance Service must be restarted for changes to the System.Maintenance.DB.* and
System.Maintenance.Session.* variables to take effect.
User Profile Elements on page 7-4
page
9-37.
Description
In minutes, how quickly the backlight times out while on battery
Default backlight level on the device. Values are 0 - 4.
Default Desktop URL for bar code input.
This setting allows the client to launch a customer business
application with a bar code scanned while the user is at the client
desktop. The sample data included references the
UCASampleApp2. Note that this URL must be in the form of an http
get request. There must be a "?" separating the Web page name
from the parameters. The URL must also end with a parameter that
doesn't have a value (i.e. "ProductBarcode="). The client software
appends the scanned bar code data to the end of the URL if the
last character of the URL is "=". Otherwise it does not include the
bar code data and loads the page specified by the URL.
Number of extensions to ask for when the first extension fails to
register.
Number of retries to register with the same extension.
Interval between successive retries.
Device side path and filename for the default client ring tone for
incoming phone calls.
Default receiver volume on the client. Values 0-6.
Default speaker volume on the client. Values 0-6.
Unicast Call Packet Rate (0-40, in steps of 10).
Call Park by Group feature.
Call Park functionality is enabled on the PBX.
Feature Access Code for Call Park on the PBX.
Feature Access Code for Call Pick on the PBX.
IP address for the phone gateway used for PBX communications.
for

Advertisement

Table of Contents
loading

Table of Contents