Motorola CA50 Developer & User Manual page 382

14 - 14 CA50/UCA Client & Server Developer & User Guide
Client Generated Error Messages (Continued)
Table 14-6
Error Set
Phone Related Errors
(continued)
Menu Related Errors
Starting Up Error
Error Message
"Not Implemented"
"Invalid DTMF tone"
"Registeration failed"
"UnRegistration failed"
"Bad or no menu data from
host. Try again."
"Menu not found x"
"Error Starting Up"
Description
This error indicates that an attempt was made to perform an
operation with the phone subsystem but the operation is not
implemented. Report problem to the help desk or technical
support. Report problem to help desk or technical support.
A DTMF tone was attempted be sent over the established
phone connection but the DTMF tone was invalid. Check the
user profile. If the problem still persists, report problem to help
desk or technical support.
A registration to a PBX server, or to a gatekeeper, or direct
CA50-to-CA50 IP based call registration failed. Check PBX,
gatekeeper, user profile and UCA server settings. If problem
still persists, report problem to help desk or technical support.
A registration to a PBX server, or to a gatekeeper, or direct
CA50-to-CA50 IP based call registration failed. Check PBX,
gatekeeper, user profile and UCA server settings. If problem
still persists, report problem to help desk or technical support.
An error occurred attempting to obtain a menu from the
Server. The response is not recognized.
x = a menu that cannot be found.
This message displays when the user presses the left soft key
Log while attempting to connect to the UCA server.
Note: If the device cannot connect to the network or find the
UCA server during the login attempt, an error message
displays, a beep sounds and a red LED blinks. A countdown
error screen appears. When the countdown is complete, an
automatic retry is attempted. If the left soft key (Log) is
pressed from the countdown screen, a Log screen displays
with a log of the attempted network connection error.
Automatic retry is disabled while in the Log screen.
From the Log screen a user can press the right soft key to go
Back to the error screen and restart automatic retry, or press
right soft key to Cancel and put the device into sleep mode.