Using The Storage Card - Intermec CN3, CN3e User Manual

Chapter 1 — Using the CN3

Using the Storage Card

28
To save picture files
1 Tap Menu (lower right) then Options to access the Camera tab.
2 Select where you want to save files to, type a filename prefix, and
select a compression level.
3 Tap ok.
The CN3 uses a miniSD card to increase file storage and install
software. The miniSD card slot is located under a door that is beneath
the battery pack. Remove the two screws holding the door to reach the
miniSD card.
You can corrupt your miniSD card if you do not follow these
installation and removal procedures exactly. Before installing a
miniSD card, inspect the gasket on the door for any damage or
wear, and contact your Intermec representative if you find any
damage or wear.
Note: The CN3 will reset if you open the miniSD/SIM door. The
screws to this door must be in place and torqued to 0.11 Nm (1.0 in-
lbs) to ensure normal operation.
To insert the miniSD card
1 Press the Power button to suspend the CN3, and then remove the
battery pack from the back of the CN3.
2 Remove the two screws on the miniSD/SIM card slot door.
3 Gently lift the door to the card slot, then with the metal contacts
facing down, insert the storage card into the miniSD card slot.
CN3 Series Mobile Computer User's Manual for Windows Mobile 5.0