8. Plug the telephone cord of a single or two-line telephone into the telephone.
9. Plug the other end of the telephone cord of a single or two-line telephone into the
port on the rear of the gateway.
TEL 1/2
Note: Contact a VoIP service provider to activate this service.
10. For a second telephone, plug the telephone wire of a single-line telephone into the
port on the rear of the SVG1501.
TEL 2
11. Check that the LEDs on the front panel cycle through the proper sequence, see
SVG1501 LED Activity During
Wall Mounting the SVG1501
You can optionally mount the SVG1501 on a wall:
•
Locate the unit as specified by the local or national codes governing residential or
business cable TV and communications services.
•
Follow all local standards for installing a network interface unit/network interface
device (NIU/NID).
•
Make sure the AC power plug is disconnected from the wall outlet and all cables are
removed from the back of the SVG1501 before starting the installation.
•
Decide if you want to mount the SVG1501 horizontally or vertically.
If possible, mount the unit to concrete, masonry, a wooden stud, or some other solid
wall material. Use anchors if necessary (for example, if you must mount the unit on
drywall).
2 • Getting Started
Startup.
B
12
Need help?
Do you have a question about the SURFboard SVG1501E and is the answer not in the manual?