Renewing Your Ip Address; Wall Mounting The Svg1501 - Motorola SURFboard SVG1501 Series User Manual

Renewing Your IP Address

To renew your IP address in Windows XP or Windows Vista:
1. Open a command prompt window.
A. From the Windows Taskbar, click Start to open the Start menu.
B. Click Run to open the Run dialog.
C. Type cmd in the Open entry box and click OK.
2. Type ipconfig /renew and press ENTER. A valid IP address should appear
indicating that Internet access is available.
3. Type exit and press ENTER to close the command prompt window.
If after performing this procedure your computer cannot access the Internet, call your
cable provider for help.

Wall Mounting the SVG1501

Do the following to mount the SVG1501 on the wall:
•
Locate the unit as specified by the local or national codes governing residential or
business cable TV and communications services.
•
Follow all local standards for installing a network interface unit/network interface
device (NIU/NID).
If possible, mount the unit to concrete, masonry, a wooden stud, or some other very
solid wall material. Use anchors if necessary (for example, if you must mount the unit on
drywall).
CAUTION: Before drilling holes, check the structure for potential
damage to water, gas, or electrical lines.
Make sure the AC power plug is disconnected from the wall outlet and all cables are
removed from the back of the SVG1501 before starting the installation.
You can mount the SVG1501 horizontally or vertically. Do the following to mount your
SVG1501 on the wall:
1. Print a coy of the
2. Measure the printed template with a ruler to ensure that it is the correct size.
3. Use a center punch to mark the center of the holes.
4. On the wall, locate the marks for the mounting holes.
5. Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). Use M3.5 x 38 mm (#6 x
11/2 inch) screws with a flat underside and maximum screw head diameter of 9.0
mm to mount the SVG1501.
6. Using a screwdriver, turn each screw until part of it protrudes from the wall, as
shown in the following wall mounting screw dimensions illustration.
2 • Getting Started
This document is uncontrolled pending incorporation in a Motorola CMS
Wall Mounting Template.
22