Set Mode: CONFIG Menu Operations
Setting the Key Operation Confirmation Sound
Set whether or not a beep sound is emitted to confirm when keys are operated, when
scanning reaches the end of a frequency band, or when a band edge/CH1 is encountered.
1
Touch [3 BEEP].
2
Rotate the DIAL to select [SELECT], then press the
3
Rotate the DIAL to select the desired setting referring to the table below.
KEY &
Emits the beep sound when a key is operated or scanning stops.
SCAN
KEY
Emits the beep sound when a key is pressed.
OFF
Mutes the beep sound.
Remark
The default setting: KEY & SCAN
4
Press the
5
Rotate the DIAL to select [EDGE], then press the
6
Rotate the DIAL to select the desired setting referring to the table below.
OFF
No confirmation sound is emitted when a band edge/CH1 is encountered.
ON
Emits the confirmation sound when a band edge/CH1 is encountered.
Remark
The default setting: OFF
Turning off the BUSY Indicator
When listening to the radio continuously or to extend the remaining battery operating
time, turn off the BUSY indicator to save battery power consumption.
1
Touch [4 BUSY LED].
2
Rotate the DIAL to select "A BAND", "B BAND" or "RADIO", then press the
3
Rotate the DIAL to select the desired setting.
ON
Turns on the BUSY indicator.
OFF
Turns off the BUSY indicator.
Remark
The default setting: ON
4
Press the
5
To change the setting for other bands, repeat steps 2 to 4.
146
.
key.
key.
key.
key.