Switching The Receive Mode; Setting The Squelch Type For The Digital Mode; Setting The Pop-Up Time Of The Remote Station Information - Yaesu FT2DR Operating Instructions Manual

Switching the Receive Mode

Manually switch to a suitable mode (radio wave type) according to the frequency band by
selecting [1 MODE] → [3 RX MODE].
For details, see "Changing the Mode" on page 48.

Setting the Squelch Type for the Digital Mode

Set the squelch type for the digital mode.
1
Touch [2 DIGITAL].
2
Touch [1 SQL TYPE].
3
Rotate the DIAL to select [SQL TYPE], then press the
4
Rotate the DIAL to select the desired squelch type.
OFF
CODE
BREAK
Remark The default setting: OFF
5
Press the key.
6
Rotate the DIAL to select [SQL CODE], then press the
7
Rotate the DIAL to select the desired code.
Set SQL CODE any one of 126 types (001 to 126).

Setting the Pop-up Time of the Remote Station Information

Set the time duration to display the remote station information such as the call sign, on
the LCD.
1
Touch [2 DIGITAL].
2
Touch [2 DIGI POPUP].
3
Rotate the DIAL to select the desired setting.
OFF The remote station information is not displayed.
BND2s to Set the time duration to display the remote station information (2 to
60s 60 seconds).
BND2s / BND4s / BND6s / BND8s / BND10s / BND20s / BND30s /
BND60s
BNDCNT The remote station information is continuously displayed.
Remark The default setting: BAND 10 seconds
Audio is always output upon receiving a digital signal from a Yaesu
transceiver.
Audio is output only when receiving a signal with a corresponding
SQL CODE.
Audio is output regardless of any squelch code when the remote
station transmits with BREAK set.
Set Mode: TX/RX Menu Operations
key.
key.
133