Tuning To A Frequency - Yaesu FT2DR Operating Instructions Manual

Performing Communication
Tips
• The frequency settings from the factory are:
A-band: 144.000 MHz
• In the default, Auto mode is set so that the transceiver will be automatically set to the optimal receive
mode for each frequency band.
To change the reception mode, press and hold
touch [TX/RX] → [1 MODE] → [3 RX MODE] (
• For the relationship between frequency bands and receive frequencies, see the table on page 36.
• To recall the home channel of each frequency band touch [F MW] followed by [HOME] (
57).

Tuning to a Frequency

Tune to the desired frequency using either of the following methods:
y Rotate the DIAL to tune to the desired frequency
1
Press the
mode.
2
Rotate the DIAL to tune to the desired frequency.
Rotate clockwise: The frequency increases.
Rotate counterclockwise: The frequency decreases.
Tip By touching [F MW] and rotating the DIAL, the
frequency will change in 1 MHz steps
y Entering the frequency directly using the numeric keys
1
Press the
mode.
2
Touch the frequency displayed on the LCD.
The numeric keypad appears.
38
B-band: 430.000 MHz
key to switch the transceiver to VFO
key to switch the transceiver to VFO
for over one second to switch to Set mode, then
see page 48).
see page