Limit The Time Of A Continuous Transmission (Tot Function); Setting The Frequency Selection Range For Operation In Vfo Mode Vfo Mode Function; Notifying A Call From A Remote Station By Vibration; Swapping The Dial Knob Functions - Yaesu FT2DR Operating Instructions Manual

Set Mode: CONFIG Menu Operations

Limit the time of a continuous transmission (TOT Function)

Set the transceiver to automatically return to receive mode after transmitting continuously
for a certain period of time. The TOT function limits inadvertent transmission of
unnecessary signals, and unwanted battery power consumption (time-out timer function).
1
Rotate the DIAL, then touch [20 TOT].
2
Rotate the DIAL to set the time for the transceiver to automatically return to receive
mode state in steps of 30 seconds.
OFF/30 SEC to 10 MIN
Selecting OFF disables the TOT function.
Remark The default setting: OFF (European version: 3 MIN)
Tips
• When the time-out timer function is active, a beep is emitted when a continuous transmission nears
the set time. About 10 seconds later, the transceiver returns to the receive mode.
• The TOT setting is retained until "OFF" is selected in step 2 above.
Setting the Frequency Selection Range for Operation in VFO Mode
VFO MODE Function
Sets the frequency tuning range while operating in VFO mode.
1
Rotate the DIAL, then touch [21 VFO MODE].
2
Rotate the DIAL to select the desired tuning range.
ALL
BAND
Remark
The default setting: ALL

Notifying a Call From a Remote Station by Vibration

Rotate the DIAL to select [22 VIBRATOR] to set the vibrator which notifies you of a call
from a remote station.
For details, see "Notification of a Call from a Remote Station by Vibration" on page 113.

Swapping the Dial Knob Functions

1
Rotate the DIAL, then touch [23 DIAL KNOB CHANGE].
2
Press the [CHANGE] key.
The VOL and DIAL knob functions are swapped.
Remark The default setting: the upper knob is DIAL.
152
Tuning continues to the next band when reaching the end of a band.
Tuning continues to the other end of the current band when reaching
the end of the band.