Resetting The All Set Mode Settings - Yaesu FT2DR Operating Instructions Manual

Using Set Mode
[When there is no deeper level of menu items]
Go to step 7.
[When there is deeper level of menu items]
5
Press the
6
Rotate the DIAL to select the desired item to set.
7
Press .
Exits from Set mode.
Caution
On some setting screens, pressing
several times to return to the frequency display screen.

Resetting the All Set Mode Settings

All the Set mode settings can be restored to the default settings by following the procedure
below.
1
Press and hold
2
While pressing the
The transceiver turns ON. When you hear a beep sound, release the keys.
3
After "SET MODE RESET?" appears, touch [OK].
A beep sounds.
Tips • To cancel resetting, touch [CANCEL].
• To reset the following items, make sure to perform All Reset (
[TX/RX]
1-1 ANTENNA ATT
1-2 HALF DEVIATION
1-3 RX MODE
2-1 SQL TYPE
[MEMORY]
2 BANK NAME
3 MEMORY NAME
5 MEMORY SKIP
[SIGNALING]
2 DCS CODE
3 DCS INVERSION
6 PAGER
7 PR FREQUENCY
9 SQL S-METER
11 SQL TYPE
12 TONE SQL FREQ
[WIRES-X]
1 RPT/WIRES FREQ
2 SEARCH SETUP
4 EDIT CATEGORY TAG
120
key.
does not exit from Set mode. In this case, press the
for over one second to turn off the transceiver.
and keys simultaneously, press
see page 51).
[CONFIG]
5 CLOCK TYPE
12 PASSWORD
15 RPT SHIFT
16 RPT SHIFT FREQ
18 STEP
[APRS]
7 APRS MSG TXT
15 BEACON STATS TXT
18 DIGI PATH
19 GPS SETUP
23 CALLSIGN (APRS)
24 MY POSITION
25 MY SYMBOL (4:User)
[CALLSIGN]
1 CALLSIGN (DIGITAL)
key
for over one second.