Searching For The Ctcss Tone Transmitted By The Remote Station - Yaesu FT2DR Operating Instructions Manual

Hide thumbs Also See for FT2DR:
Table of Contents

Advertisement

4
Rotate the dial to select the desired tone frequency.
5
Gently press the
The selected tone frequency is set and the transceiver exits from Set mode.
Tips
• The tone frequency set by following the procedure above is also effective when tones are only
transmitted.
• The default setting is 100 Hz.

Searching for the CTCSS Tone transmitted by the Remote Station

Search and display the tone squelch CTCSS tone transmitted by the remote station.
1
Press and hold the
The transceiver enters Set mode.
2
Touch [SIGNALING].
3
Rotate the DIAL, then touch [11 SQL TYPE].
4
Rotate the DIAL to select [TONE SQL].
5
Press the
key.
6
Rotate the DIAL, then touch [12 TONE SQL FREQ].
7
Receive the signal from the remote station.
8
Touch [SRCH].
The transceiver begins searching for a matching tone frequency
When a corresponding tone frequency is detected, a beep sound is emitted and
searching stops temporarily. The detected tone frequency blinks.
Tip
To set CTCSS to the detected tone frequency,
Touch [STOP]. → Hear the beep sound. → Gently press the
The transceiver exits from Set mode.
Tip
To set the transceiver operation when scanning stops, see "Setting the Receive Operation When
Scanning Stops" on page 74.
key 3 times.
key for over one second.
Using the Tone Squelch Function
key 3 times.
111

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft2deFt2drde

Table of Contents