Preparation; Attaching The Supplied Accessories; Installing The Antenna; Attaching The Accessory Protective Cap/Belt Clip - Yaesu FT2DR Operating Instructions Manual

Attaching the Supplied Accessories

Installing the Antenna

1
Align the bottom side of the antenna with the antenna connector
on the transceiver.
Caution
Be sure to hold the thick base of the antenna when installing it
2
Turn the antenna clockwise until it is secured.
Cautions
y Do not hold or twist the upper part of the antenna when
installing or removing it. To do so may break the conductors
inside the antenna.
y Do not key the transmit without installing the antenna. The
transmitter components may be damaged.
y When using an antenna other than the one supplied, or
connecting to an external antenna, ensure that the SWR is
adjusted to 1.5 or lower.

Attaching the Accessory Protective Cap/Belt Clip

Attaching the Protective Cap

If you do not use the belt clip, install the protective cap to
cover the belt clip attaching screw holes on the battery
pack.

Attaching the Belt Clip

1
Turn the battery pack over.
2
Attach the belt clip to the battery pack using the
supplied screws (two).
Cautions
y Be sure to use the supplied screws when attaching the belt
clip. If any other screws are used, the belt clip cannot be
secured firmly to the battery pack and the transceiver may
drop off together with the battery pack; the transceiver and
battery pack may fall off, causing injury, breakage and other
damage.
y Be sure to attach the protective cap when the belt clip is not
used.
20

Preparation