Attenuator (Att) Function - Yaesu FT2DR Operating Instructions Manual

Miscellaneous Settings

Attenuator (ATT) Function

If the remote station signal is too strong or there is a strong signal nearby disturbing you
from hearing the remote station signal, switch the attenuator to ON. When there is no
reception problem, there is no need to switch the attenuator ON.
1
Press and hold the
The transceiver enters Set mode.
2
Touch [TX/RX].
3
Touch [1 MODE].
4
Touch [1 ANTENNA ATT].
The current setting is displayed.
5
Rotate the DIAL to select [ON].
6
Press .
The transceiver exits from Set mode.
50
(except AM broadcasts and AM broadcasts)
key for over one second.