Yaesu FT2DR Operating Instructions Manual page 124

Tables of Set Mode Operations
Set mode no. / item
11 TIMER
12 PASSWORD
13 PTT DELAY
14 RPT ARS
15 RPT SHIFT
16 RPT SHIFT FREQ
17 SAVE RX
18 STEP
19 DATE & TIME ADJ Set the built-in clock.
20 TOT
21 VFO MODE
22 VIBRATOR
23 DIAL KNOB
CHANGE
APRS
1 APRS AF DUAL
2 APRS DESTINATION Display the model code.
3 APRS FILTER
4 APRS MODEM
5 APRS MSG FLASH
124
Description
Switch the timer between ON and
OFF.
Input the password.
Set the PTT delay time.
Turn the ARS function on/off.
Set the repeater shift direction.
Set the repeater shift width.
Set the receive save time.
Set the channel step.
Set the timeout timer.
Select the frequency selection range
in the VFO mode.
Select a vibrator mode and set up
the vibrator function.
Swap the DIAL and VOL knob
functions.
Turn on/off the muting function when
both the APRS function and AF dual
function are active.
Select the filter function.
Set the APRS baud rate.
Set the strobe to flash when there is
an incoming message.
Selectable options
(Options in bold are the default settings)
ON: 00:00 to 23:59 ☒ /
OFF: 00:00 to 23:59 ☒ /
OFF / [****]
OFF / 20ms / 50ms / 100ms /
200ms
ON / OFF
SIMPLEX / -RPT / +RPT
0.000MHz to 150.000MHz
OFF / 0.2 SEC (1:1) to 60.0 SEC
(1:300)
AUTO / 5.0KHz / 62.5KHz /
8.33KHz / 9.0KHz / 10.0KHz /
12.5KHz / 15.0KHz / 20.0KHz /
25.0KHz / 50.0KHz / 100KHz
–
OFF / 30 SEC to 10 MIN
(European version: 3 MIN)
ALL / BAND
MODE: OFF / BUSY /
SIGNALING
SELECT: PATTERN1 /
PATTERN2 / PATTERN3
–
ON / OFF
APY02D (Uneditable)
Mic-E: ON / OFF
POSITION: ON / OFF
WEATHER: ON / OFF
OBJECT: ON / OFF
ITEM: ON / OFF
STATUS: ON / OFF
OTHER: ON / OFF
ALTNET: ON / OFF
OFF / 1200bps / 9600bps
MSG: OFF / 2s to 60s /
CONTINUOUS / EVERY 2s to
EVERY 10s 4sec
GRP: OFF / 2s to 60s /
CONTINUOUS 4sec
BLN: OFF / 2s to 60s /
CONTINUOUS 4sec
Page
149
149
150
150
150
151
151
47
43
152
152
113
152
–
–
–
–
–