Changing The Number Of Times The Bell Rings - Yaesu FT2DR Operating Instructions Manual

4
Rotate the DIAL to select [SELECT], then press the
key.
5
Rotate the DIAL to select [BELL].
6
Press .
The Bell function is activated to on and the transceiver exits from Set mode.
When the tone squelch or DCS code is set,
Tip To deactivate the Bell function, select [OFF] in step 5.
Tips
• To use the Bell function, set the tone squelch or DCS to on.
• The bell function cannot be used via the repeater.
• When the bell function is on,
When a signal is received from a remote station,
• When a signal is received from a remote station,
When pressing to perform transmission,
and lights up.

Changing the Number of Times the Bell Rings

1
Press and hold the
The transceiver enters Set mode.
2
Touch [SIGNALING].
3
Touch [1 BELL].
4
Rotate the DIAL to select [RINGER], then press the
5
Rotate the DIAL to select the desired number of times the Bell rings.
Remark The default setting: Once
Tip You can select the number of times the bell rings from among 1 to 20 times, or continuous.
6
Press .
The setting is applied and the transceiver exits from Set mode.
appears on the LCD.
blinks.
stops blinking
key for over one second.
Using the Tone Squelch Function
appears.
blinks.
key.
115