Changing High Beam Bulb; Changing Low Beam Bulb - APRILIA RS 50 Workshop Manual

Electrical system
CHANGING
HIGH BEAM BULB
NOTE
Remove the bulb sockets one by one in such
a way as to avoid replacing them incorrectly during
reassembly.
If the bulb sockets must all be removed at the same
time, take great care to reassemble them in the proper
position.
Working from the rear right side of the front part of the
fairing, pull back the rubber boot (1) with your fingers.
Rotate the bulb socket (2) counterclockwise and
remove it.
Push the bulb (3) toward the back of the socket lightly,
and rotate it counterclockwise.
Remove the bulb from the seat.
NOTE
Be sure to maintain the same orientation as
the old bulb when you install the new bulb.
Do not force the bulb, it will go easily if it is properly
oriented.
CHANGING
LOW BEAM BULB
NOTE
Remove the bulb sockets one by one in such
a way as to avoid replacing them incorrectly during
reassembly.
If the bulb sockets must all be removed at the same
time, take great care to reassemble them in the proper
position.
Working from the rear left side of the front part of the
fairing, pull back the rubber boot (4) with your fingers.
Rotate the bulb socket (5) counterclockwise and
remove it.
Push the bulb (6) toward the back of the socket lightly,
and rotate it counterclockwise.
Remove the bulb from the seat.
NOTE
Be sure to maintain the same orientation as
the old bulb when you install the new bulb.
Do not try to force the bulb, it will go easily if it is
properly oriented.
ch. 6
1
6
Release 00 2001-03
RS 50
2
3
5
4
6-25
6