Body work
RS 50
REMOVING THE RIGHT HANDLEBAR
2
ELECTRICAL CONTROLS
Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Position the motorcycle on the stand.
Switch the ignition key to the " " position.
The only operation required is to disconnect the
throttle cable (1) from the block.
Free the wiring from the clamps that fix it to the frame.
3
1
NOTE
Prepare the same number of new clamps for
refitting.
Disconnect the electrical connector on the right high/
low beam selector.
Remove the two half shells (2-3).
Make sure the connector is plugged in properly when
refitting.
REMOVING THE STOP SWITCH
4
Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Position the motorcycle on the stand.
Switch the ignition key to the " " position.
Loosen and remove the 2 screws (4).
CAUTION
5
Before removing the stop light switch, put your
hand under it to catch the ball (6) as it falls.
6
Remove the stop switch (5) and catch the ball (6),
unplugging the switch from the electrical connection.
When refitting, make sure the electrical connec-
tion is plugged in properly.
4
7-12
ch. 7
Release 00
2001-03