APRILIA RS 50 Workshop Manual page 143

Body work
RS 50
NOTE
Make sure the electrical connections are
6
correct when refitting.
7
7
Loosen and remove the 3 self-locking nuts (7) and
washers.
Torque wrench setting for nut (7):
10 Nm (1 kgm) [7.4 Ft-lb].
Remove the dashboard (6).
NOTE
Replace the rubber pads, if damaged.
7
REMOVING THE INSTRUMENT PANEL
1
FRAME
Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Position the motorcycle on the stand.
Switch the ignition key to the " " position.
4
Remove the front fairing (REMOVING THE FRONT
FAIRING).
Remove the dashboard (REMOVING THE DASH-
BOARD).
2
3
Free the instrument panel frame (1) from the wiring (2)
by cutting the clamps (3).
CAUTION
When refitting, replace the clamps (3) with new
ones.
Loosen and remove the 2 screws (4), taking off the
corresponding self-locking flanged nuts from the other
side.
Torque setting for screws (4):
15 Nm (1.5 kgm) [11.1 Ft-lb].
7-18
ch. 7
Release 00 2001-03