Removing The Rear Light; Removing The License Plate Holder - APRILIA RS 50 Workshop Manual

Body work
RS 50

REMOVING THE REAR LIGHT

Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Switch the ignition key to the " " position.
Carry out the procedure for changing the rear light
bulb (CHANGING THE REAR LIGHT BULB).
Withdraw and slightly loosen the reflector (1).
1
3
Disconnect the bulb electrical connection (2).
Remove the reflector (1).
Loosen and remove the 2 retainer screws (3).
Torque setting for screws (3):
2
4
2 Nm (0.2 kgm) [1.5 Ft-lb].
Remove the taillight support (4).
NOTE
When reassembling, tighten the two screws
(3) carefully and moderately, to avoid damaging the
taillight support (4).
REMOVING THE LICENSE PLATE
HOLDER
Read carefully (PRECAUTIONS AND GENERAL
INFORMATION).
Switch the ignition key to the " " position.
Remove the rear fairing (REMOVING THE REAR
FAIRING).
Remove the taillight (REMOVING THE REAR LIGHT).
Remove the rear direction indicators (REMOVING
THE REAR DIRECTION INDICATORS).
Loosen and remove the 3 screws (5). 6
Remove the three self-locking nuts (6).
Remove the license plate holder (7) from the pillar
lower closing cowl (8).
7
8
5
7-22
ch. 7
Release 00 2001-03