Change Fuses - APRILIA RS 50 Workshop Manual

Electrical system
Depending on the beam adjustment to be carried out,
select:
the group necessary for the adjustment;
the direction (to the right or to the left).
NOTE
Do not mix up screws and shims. Use them
only in the proper sets.
Insert the shims in the headlight screw seats as
indicated in figures A and B:
rightwards (figure A);
leftwards (figure B).
Position the headlight (3) in its seat.
Tighten the lower left screw (1).
NOTE
Replace the screws (2) with the specific
screws corresponding to each shim.
Keep the screws (2) and shims that you do not use
together in the tool kit, in case further adjustment is
required.
Tighten the two screws specific for each shim.
Tighten the remaining three screws.
Tighten the three screws.
Replace the front part of the fairing, see (REMOVING
THE FRONT PART OF THE FAIRING).
Make sure that the horizontal adjustment of the head-
light beam is correct.
Make sure that the vertical adjustment of the headlight
beam is correct, see (ADJUSTING THE HEADLIGHT
BEAM VERTICALLY).

CHANGE FUSES

Read carefully (SERVICING SCHEDULE).
CAUTION
Do not repair faulty fuses.
Use only recommended fuses. Using fuses of an
improper capacity can cause damage to the
electrical system or an electrical fire, which could
result in total destruction of your motorcycle as
well as injury to you.
NOTE
If a fuse blows frequently, there probably is a
short circuit or an overload in the electrical system. If
this occurs, take the motorcycle to your Local aprilia
Dealer.
ch. 6
1
2
Release 00 2001-03
RS 50
3
2
6
6-29