APRILIA RS 50 Workshop Manual page 128

Body work
NOTE
The application tape (1), if present, must be
removed 20-30 minutes after the application of the
transfer.
The tape is used in the application of logos and
letters, making it easier to position them correctly on
the surface and helping the glue to set more firmly.
Peel off the application tape (5) from the transfer
surface.
Go over the transfer again with the squeegee to make
sure it has adhered properly, especially the edges and
corners.
NOTE
With the wet application method, the transfer
takes 48 hours to set properly.
Make sure there are no air bubbles under the surface
after removing the application tape.
If there are any air bubbles, use a sharp pin or cutter
(6) to puncture the edge (7) of the air bubble.
Using the squeegee (1) and starting from the opposite
side to the puncture, smooth down the bubble and
force the air out.
ch. 7
5
6
7
Release 00 2001-03
RS 50
7
7
7-3