Problems Related To Copy Results - Sharp MX-C382SC Operation Manual

PROBLEMS RELATED TO COPY RESULTS

Problem
The image is too light
or too dark.
Colours are off.
Part of the image is
cut off.
Copies come out
blank.
Point to check
Is the image too light or too dark?
Has an appropriate exposure mode for
the original type been selected?
Did you perform "Registration
Adjustment"?
Has an appropriate ratio been selected
for the original size and paper size?
Are you using an inch (AB) size
original?
Has the correct original size been set?
Is the original placed face up or face
down correctly?
Select an appropriate exposure mode for the
original being copied and adjust the exposure level
manually.
Select one of the following modes depending on the
original type.
• Text
Use this mode for regular text documents.
• Text/Prtd.Photo
This mode provides the best balance for copying an
original which contains both text and printed
photographs, such as a magazine or catalogue.
• Text/Photo
This mode provides the best balance for copying an
original which contains both text and photographs,
such as a text document with a photo pasted on.
• Printed Photo
This mode is best for copying printed photographs,
such as photos in a magazine or catalogue.
• Photo
Use this mode to copy photos.
• Map
This mode is best for copying the light colour shading
and fine text found on most maps.
• Light original
Use this mode for originals with light pencil writing.
Ask your administrator to perform "Registration
Adjustment".
If the colours are out of position in the printed output of a
colour copy job, "Registration Adjustment" can be used
to adjust the print position of each colour.
➞ System Settings (Administrator) > "Device Control" >
"Other Settings" > "Registration Adjustment"
If the colour tones are off, perform "Auto Colour
Calibration". (If the colours are still off after calibration,
repeating calibration may improve the results.)
➞ System Settings (Administrator) > "Copy Function
Settings" > "Colour Adjustment" > "Auto Colour
Calibration"
Select an appropriate ratio setting.
When copying an inch (AB) size original, specify the
original size manually.
Touch the [Original] key and select the correct size.
When using the document glass, the original must
be placed face down. When using the automatic
document feeder, the original must be placed face
up.
8-21
TROUBLESHOOTING
Solution
Contents