Sharp MX-C382SC Operation Manual page 557

(1)
Scan/Special Modes
Erase
Edge
Erase
Side Erase
4
Press the [COLOUR START] key or the [BLACK & WHITE START] key.
Scanning begins.
• If you inserted the original pages in the document feeder tray, all pages are scanned.
A beep will sound to indicate that scanning is finished.
• If you are scanning the original on the document glass, scan each page one page at a time.
When scanning of one page finishes, replace it with the next page and press the [COLOUR START] key or the [BLACK &
WHITE START] key. Repeat until all pages have been scanned and then press the [Read-End] key.
5
A beep will sound to indicate that scanning is finished.
If the destination is an Internet fax destination, press the [BLACK & WHITE START] key.
To cancel scanning...
Press the [STOP] key (
When the erase function is used, erase takes place at the edges of the original image. If you also use a reduction or an
enlargement setting, the erase width will change according to the selected ratio. For example, if the erase width setting is
20 mm (1") and the image is reduced to 50%, the erase width will be 10 mm (1/2").
To cancel the erase setting...
Touch the [Cancel] key in the screen of step 4.
System Settings (Administrator): Erase Width Adjustment
The default erase width setting is linked to the copy mode system setting, and can be set from 0 mm to 20 mm (0" to 1"). The
factory default setting is 10 mm (1/2").
Select the erase settings.
(2) (3)
(1) Touch the desired erase mode.
OK
Cancel OK
Edge
10
(0~20)
mm
(2) Set the erasure width with the
(3) Touch the [OK] key.
) to cancel the operation.
5-75
SCANNER/INTERNET FAX
Select one of the 2 erase modes.
Touch the [Side Erase] key to open the following screen.
Erase
Side Erase
Up
Left Right
Down
Touch the checkbox of the edge that you wish to erase
and make sure that a checkmark (
When performing two-sided scanning, set the erase edge
on the reverse side.
• If you touch the [Same Side as Side 1] key, the edge in
the same position as on the front side will be erased.
• If you touch the [Different Side from Side 1], the edge in
the position opposite to the erased edge on the front
side will be erased.
When you have completed the settings, touch the [OK] key.
0 mm to 20 mm (0" to 1") can be entered.
Cancel OK
Erase position
for Original Side 2
Same Side as
Side 1
Different Side
from Side 1
) appears.
keys.
Contents