Sharp MX-C382SC Operation Manual page 433

Press the [BLACK & WHITE START] key to scan the first set.
4
To cancel scanning...
Press the [STOP] key (
Insert the next set of originals and press the [BLACK & WHITE START] key.
Repeat this step until all originals have been scanned.
5
To cancel scanning...
Press the [STOP] key (
Place next original.
Press [Start].
When finished, press [Read-End].
6
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned.
• If the memory becomes full during scanning, a message will appear and the transmission will be cancelled.
• This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Job Build....
Touch the [Job Build] key in the screen of step 3 so that it is not highlighted.
).
). All scanned data will be cleared.
(Pg.No.x)
Configure Read-End
4-80
Touch the [Read-End] key.
FACSIMILE
Contents