Sharp MX-C382SC Operation Manual page 809

Problem
Transmission does
not take place.
The transmitted fax
prints out blank at the
receiving side.
The transmitted fax is
reduced by the
receiving fax machine.
Transmission does
not begin at the
specified time.
Point to check
Does the job status screen (completed
jobs) or a transaction report indicate that
the transmission was not successful?
Did you place a long size original on the
document glass when it is scanned?
Are the sub-address and passcode
correct?
(When using F-code communication)
Have functions been disabled by the
administrator?
Is the original placed face up or face
down correctly?
If the receiving machine is using thermal
paper, was the thermal paper loaded
with the wrong side out?
Has image rotation been enabled?
Is the machine's clock set to the correct
time?
Is a transmission in progress?
Perform the transmission again.
If the transmission is still not successful after recalling is
performed as set in "Recall in Case of Line Busy" or
"Recall in Case of Communication Error", the
transmission failure will be indicated in the job status
screen and the transaction report.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Line Busy"
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Communication Error"
Place originals in the document feeder tray of the
automatic document feeder.
A long size original cannot be scanned from the
document glass.
Check with the operator of the other machine to
make sure that the sub-address and passcode are
correct.
Check with your administrator.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Place the original correctly and send the fax again.
When using the document glass, the original must be
placed face down. When using the automatic document
feeder, the original must be placed face up. Place the
original correctly and send the fax again.
Check with the operator of the receiving machine.
Enable "Rotation Sending Settings" before
transmission.
When "Rotation Sending Setting" is not enabled (the
image is not rotated), an original placed in the vertical
orientation may be reduced by the receiving machine.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Rotation Sending Setting" >
If "Mixed Size Originals" in the special modes is enabled
and an original with a different width is sent, rotate
transmission will be disabled.
Set the clock to the correct time.
➞ System Settings > "Default Settings" > "Clock" >
"Clock Adjust"
If another transmission is in progress when the specified
time arrives, the timer operation will begin after that
transmission is finished.
8-30
TROUBLESHOOTING
Solution
Contents