Fax Card Removal - Lexmark MX910de Service Manual

4
Disconnect the cables, and then remove the 12 screws (A).
5
Remove the board.
Installation notes:
a
After installing the new controller board, restore the printer configuration. See
after replacing the controller board" on page
b
Restore the eSF solutions and settings. See Importing eSF solutions and settings file under
and settings" on page
c
Create a backup of the engine settings by copying them from the engine controller board to the new controller
board. See "Restore Backup Data" on page

Fax card removal

Note: This part is not a FRU.
1
Remove the scanner interface cable cover. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the upper rear cover. See
242.
247.
225.
"Scanner interface cable cover removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Upper rear cover removal" on page
Repair information
"Restoring the printer configuration
346.
346.
357
7421
"Backing up eSF solutions
344.
345.