Table of Contents
Advertisement
4
Move the paper stack transfer guide.
5
Loosen the tension screw (C) and then move the belt (D) to adjust.
6
Retighten the tension screw.
Removal procedures
When replacing printer parts, consider the following:
•
Some removal procedures require removing cable ties. Replace cable ties during reassembly to avoid pinching wires,
obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging units, developer units, photoconductor units, and trays before removing
other printer parts.
•
Place the imaging or photoconductor unit on a clean, smooth, and flat surface. Do not expose the photoconductor
drum to light.
•
Disconnect all external cables from the printer to prevent possible damage during service.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held by several screws, start all screws before the final tightening.
D
Repair information
271
C
7421
Advertisement
Table of Contents
