Toner Specks Check - Lexmark MX910de Service Manual

Actions
Step 4
a
Make sure that the induction heater is properly installed.
b
Reseat the heater cable.
c
Check the heater and its cable for damage, and replace if necessary.
See "Induction heater removal" on page
Does the problem remain?
Step 5
a
Make sure that the induction heater power supply is properly
installed.
b
Reseat the power supply cables.
c
Check the power supply and its cables for damage, and replace if
necessary. See "Induction heater power supply (IHPS) removal" on
page 350.
Does the problem remain?

Toner specks check

Actions
Step 1
a
Make sure that the photoconductor and printhead are clean.
b
Make sure that the photoconductor and printhead are properly
installed.
c
Check the photoconductor for damage, and replace if necessary.
Does the problem remain?
Step 2
a
Make sure that the cartridge and photoconductor are installed.
b
Make sure that the cartridge and photoconductor are supported.
Does the problem remain?
279.
Diagnostic information
58
Yes No
Go to step 5. The problem is solved.
Contact the next level The problem is solved.
of support.
Yes No
Go to step 2. The problem is solved.
Go to step 3. The problem is solved.
7421