7
Disconnect the cables, remove the four screws (A), and then release the latch (B).
8
Remove the board.
Motor (registration) removal
1
Remove the port access door. See
2
Remove the controller board access cover. See
3
Remove the engine board cover. See
4
Remove the scanner interface cable cover. See
5
Remove the upper rear cover. See
6
Open the controller board frame. See
A
B
"Port access door removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
"Scanner interface cable cover removal" on page
"Upper rear cover removal" on page
"Controller board frame removal" on page
Repair information
370
278.
346.
346.
365.
7421
345.
344.