Removing The Ecu (Engine Control Unit); Installing The Ecu (Engine Control Unit); Installing The Electrical Components Trays - Yamaha 2014 MT-07 Service Manual

EAS31108

REMOVING THE ECU (engine control unit)

1. Disconnect:
• ECU coupler "1"
TIP
While pushing the portion "a" of the ECU cou-
pler, move the lock lever "b" in the direction of
the arrow shown to disconnect the coupler.
1
EAS31109

INSTALLING THE ECU (engine control unit)

1. Connect:
• ECU coupler "1"
TIP
Connect the ECU coupler, and then push the
lock lever "a" of the coupler in the direction of the
arrow shown.
1
EAS31129
INSTALLING THE ELECTRICAL
COMPONENTS TRAYS
1. Install:
• Electrical components tray 2 "1"
Electrical components tray 2 nut
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Electrical components tray 2 bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
Tighten the electrical components tray 2 nuts
and bolt in the proper tightening sequence as
shown.
b
a
a
GENERAL CHASSIS (5)
2
2. Install:
• Fuel tank cover bracket "1"
• Electrical components tray 1 "2"
Electrical components tray 1 bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
TIP
Make sure that the projection "a" on the fuel tank
cover bracket contacts the frame.
3. Install:
• Intake air pressure sensor "1"
Intake air pressure sensor bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
TIP
Make sure that the intake air pressure sensor
contacts the frame.
4-17
1
1 1
2
1
a
1