Checking The Coolant Level; Checking The Cooling System; Changing The Coolant - Yamaha 2014 MT-07 Service Manual

Main gallery bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
TIP
Lubricate the O-ring with a thin coat of lithium-
soap-based grease.
EAS30811

CHECKING THE COOLANT LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on a suitable stand.
• Make sure the vehicle is upright.
2. Check:
• Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add the
recommended coolant to the proper level.
a
b
ECA13470
NOTICE
• Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Check:
• Coolant level
TIP
Before checking the coolant level, wait a few
minutes until it settles.
PERIODIC MAINTENANCE
EAS30812

CHECKING THE COOLING SYSTEM

1. Check:
• Radiator "1"
• Radiator inlet hose "2"
• Radiator outlet hose "3"
• Oil cooler "4"
• Oil cooler inlet hose "5"
• Oil cooler outlet hose "6"
• Water jacket joint "7"
• Water jacket joint inlet hose "8"
• Thermostat cover "9"
• Thermostat "10"
• Water pump inlet pipe "11"
• Water pump outlet pipe "12"
Cracks/damage → Replace.
Refer to "RADIATOR" on page 6-1, "OIL
COOLER" on page 6-4, "THERMOSTAT" on
page 6-7 and "WATER PUMP" on page 6-9.
7
8
9
10
EAS30813

CHANGING THE COOLANT

1. Remove:
• Radiator cap bolt "1"
• Radiator cap "2"
EWA13030
WARNING
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the en-
gine is hot. Scalding hot fluid and steam may
be blown out, which could cause serious in-
jury. When the engine has cooled, open the
radiator cap as follows:
3-24
11
12
6
4
2
1
3
5