Yamaha 2014 MT-07 Service Manual page 291

Removing the cylinder head
10 Nm (1.0 m
16 Nm (1.6 m
55 Nm (5.5 m kgf, 40 ft
•
1
2
New
S
10 Nm (1.0 m kgf, 7.2 ft
•
25 Nm (2.5 m kgf, 18 ft
•
New
75 Nm (7.5 m
* Following the tightening order, loosen the bolt one by one, and then retighten it to the specific torque.
Order
Muffler assembly
Oil cooler inlet hose
Radiator
Cylinder head cover/Intake camshaft/Exhaust
camshaft
Clutch cover
Thermostat
1 Coolant temperature sensor coupler
2 Coolant temperature sensor
3 Engine bracket bolt (left)
New
kgf, 7.2 ft Ibf)
• •
kgf, 12 ft Ibf)
• •
Ibf)
•
Ibf)
•
Ibf)
•
kgf, 54 ft Ibf)
• •
Job/Parts to remove
1st 10 Nm (1.0 m
(6)
40 Nm (4.0 m
2nd
20 Nm (2.0 m
*
3rd
Specified angle 90˚
3
E
3
LT
55 Nm (5.5 m kgf, 40 ft Ibf)
• •
Q'ty
Refer to "ENGINE REMOVAL" on page 5-4.
Disconnect.
Refer to "OIL COOLER" on page 6-4.
Refer to "RADIATOR" on page 6-1.
Refer to "CAMSHAFTS" on page 5-13.
Refer to "CLUTCH" on page 5-50.
Refer to "THERMOSTAT" on page 6-7.
1 Disconnect.
1
2
5-26
CYLINDER HEAD
kgf, 7.2 ft Ibf)
• •
kgf, 29 ft Ibf)
• •
kgf, 14 ft Ibf)
• •
25 Nm (2.5 m kgf, 18 ft Ibf)
• •
75 Nm (7.5 m kgf, 54 ft
•
10 Nm (1.0 m kgf, 7.2 ft
•
Remarks
Ibf)
•
Ibf)
•