Yamaha 2014 MT-07 Service Manual page 101

1. Rear wheel sensor lead
2. Rear brake fluid reservoir hose
3. Brake hose (rear brake master cylinder to
hydraulic unit)
4. Brake hose (hydraulic unit to rear brake
caliper)
5. O sensor lead
2
6. Rear brake light switch lead
A. Route the rear wheel sensor lead to the
outside of the brake hose (hydraulic unit to
rear brake caliper). Make sure that the rear
wheel sensor lead is not twisted.
B. Align the holder with the pipe section of the
brake hose (hydraulic unit to rear brake
caliper).
C. Position the holder halfway between the
guide and the end of the protective sleeve on
the rear wheel sensor lead as shown in the
illustration.
D. Route the brake hoses to the inside of the
frame.
E. To O sensor
2
F. Fasten the grommets on the rear wheel
sensor lead and the brake hose (hydraulic
unit to rear brake caliper) with the holder.
G. Fasten the rear wheel sensor lead and brake
hose (hydraulic unit to rear brake caliper) with
the holder. Route the rear wheel sensor lead
over the brake hose (hydraulic unit to rear
brake caliper). Align the holder with the pipe
section of the brake hose (hydraulic unit to
rear brake caliper), making sure that the white
tape on the rear wheel sensor lead is
positioned to the front of the holder.
H. White tape
I. Route the rear brake light switch lead and O
sensor lead to the inside of the rear wheel
sensor lead.
J. Route the brake hoses on top of the frame.
K. Point the end of the plastic locking tie
rearward, and then cut off the excess end of
the tie to 5 mm (0.20 in) or less.
L. Route the rear wheel sensor lead and brake
hose (hydraulic unit to rear brake caliper)
through the guide.
2
2-56
CABLE ROUTING