Yamaha 2014 MT-07 Service Manual page 468

Fault code No.
Item
B-9 Delete the fault code.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
Procedure
Probable cause of malfunc-
Item
tion and check
C-1 Locate the malfunction.
42
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Gear position switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
42
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Gear position switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Able to start engine
Able to drive vehicle
21
Clutch switch
• "ON" (when the clutch lever is squeezed with the transmission in gear
and when the sidestand is retracted)
• "OFF" (when the clutch lever is squeezed with the transmission in gear
and when the sidestand is extended)
Operate the transmission, clutch lever, and sidestand.
Maintenance job
Execute the diagnostic mode.
(Code No. 07)
Rotate the rear wheel by hand
and check that the indicated val-
ue increases.
Execute the diagnostic mode.
(Code No. 21)
When the transmission is in
neutral: "ON"
When the transmission is in
gear with the clutch lever re-
leased: "OFF"
When the transmission is in
gear with the clutch lever
squeezed and the sidestand re-
tracted: "ON"
8-63
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
and then rotate the rear wheel
by hand.
Start the engine, and input the
vehicle speed signals by operat-
ing the vehicle at 20 to 30 km/h
(12 to 19 mph).
Check that the fault code num-
ber is not displayed.
The fault code can also be de-
leted by activating the diagnos-
tic mode and selecting
diagnostic code number "63".
Confirmation of service com-
Value does not increase → Go
to item A-2 for the rear wheel
sensor.
Incorrect indication → Go to
item B-2 for the gear position
switch.
Incorrect indication → Go to
item C-2.
pletion