Yamaha 2014 MT-07 Service Manual page 31

Self-diagnosis device
1
2
1. Error code display
2. Engine trouble warning light "
3. Immobilizer system indicator light "
This model is equipped with a self-diagnosis de-
vice for various electrical circuits.
If a problem is detected in any of those circuits,
the engine trouble warning light will come on and
the display will indicate a fault code.
If the display indicates any fault codes, note the
code number, and then check the fuel injection
system. (Refer to "FUEL INJECTION SYSTEM"
on page 8-33.)
The self-diagnosis device also detects problems
in the immobilizer system circuits.
If a problem is detected in the immobilizer sys-
tem circuits, the immobilizer system indicator
light will flash and the display will indicate a fault
code.
TIP
If the display indicates fault code 52, this could
be caused by transponder interference. If this
fault code appears, try the following.
1. Use the code re-registering key to start the
engine.
TIP
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal inter-
ference, which may prevent the engine from
starting.
3
"
"
1-22
2. If the engine starts, turn it off and try starting
the engine with the standard keys.
3. If one or both of the standard keys do not start
the engine, take the vehicle, the code re-reg-
istering key and both standard keys. If the
display indicates any fault codes, note the
code number, and then check the vehicle.
ECA20360
NOTICE
If the display indicates a fault code, the vehi-
cle should be checked as soon as possible
in order to avoid engine damage.
Brightness control mode
1. Brightness level display
This function allows you to adjust the brightness
of the multi-function meter unit panel to suit the
outside lighting conditions.
[To adjust the brightness]
1. Turn the key to "OFF".
2. Push and hold the left set button.
3. Turn the key to "ON" and continue pushing
the left set button until the display switches to
the brightness control mode.
4. Push the right set button to set the brightness
level.
5. Push the left set button to confirm the select-
ed brightness level and exit the brightness
control mode.
FEATURES
1