Assembling The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha 2014 MT-07 Service Manual

EAS30163

ASSEMBLING THE REAR WHEEL

ECA21050
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Install:
New
• Wheel bearings
New
• Oil seal
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-22.
EAS30164
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-22.
EAS30165
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Install:
• Rear brake disc
• Rear wheel sensor rotor
Rear wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
Rear brake disc bolt
30 Nm (3.0 m·kgf, 22 ft·lbf)
LOCTITE®
ECA21010
NOTICE
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and wheel
sensor bolts with new ones.
TIP
• Install the wheel sensor rotor with the stamped
mark "a" facing outward.
• Install the brake disc so that the recessed por-
tions of the bolt holes "b" face away from the
hub.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
LT
2. Install:
• Rear wheel sprocket
Refer to "CHECKING AND REPLACING
THE REAR WHEEL SPROCKET" on page
4-31.
3. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-55.
4. Lubricate:
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
5. Install:
• Collar (right)
• Collar (left)
• Brake caliper bracket "1"
• Rear wheel
• Chain pullers "2"
• Drive chain slack adjusting plates
• Rear wheel axle
• Washer
• Wheel axle nut
• Swingarm end plates "3"
4-32
REAR WHEEL
a
A
b