Yamaha 2014 MT-07 Service Manual page 111

1. Throttle cable (accelerator cable)
2. Throttle cable (decelerator cable)
3. Intake air pressure sensor
4. Intake air pressure sensor hose
5. Fuel hose
6. Air filter case
7. Throttle body assembly
8. Air filter case valve
9. Intake solenoid vacuum hose (intake solenoid
to air filter case valve)
10. Cylinder head breather hose
11. Intake solenoid vacuum hose (throttle body to
one-way valve)
12. One-way valve
13. Intake solenoid vacuum hose (one-way valve
to intake solenoid)
14. Intake solenoid
15. Surge tank
16. Surge tank hose
A. Install the intake air pressure sensor hose up
to the bend in the hose fitting of the intake air
pressure sensor.
B. Make sure that the hose is not twisted.
C. Install the intake air pressure sensor hose
onto the throttle body assembly, making sure
that the hose contacts the throttle body
assembly.
D. Forward
E. Install the intake solenoid vacuum hose
(intake solenoid to air filter case valve) up to
the bend in the hose fitting of the air filter case
valve.
F. Fasten the intake solenoid vacuum hose
(intake solenoid to air filter case valve) with
the holders as shown in the illustration.
G. Face the green paint mark on the intake
solenoid vacuum hose (intake solenoid to air
filter case valve) to the right. Align the center
of the green paint mark with the center of the
holder on the air filter case.
H. Install the intake solenoid vacuum hose
(throttle body to one-way valve) onto the
throttle body assembly, making sure that the
hose contacts the throttle body assembly.
I. Face the red paint mark on the intake
solenoid vacuum hose (throttle body to one-
way valve) downward.
J. Face the yellow paint mark on the intake
solenoid vacuum hose (throttle body to one-
way valve) to the right.
K. 90°
L. Position the ends of the hose clamp within the
range shown in the illustration.
M. Face the blue paint mark on the cylinder head
breather hose upward. Install the cylinder
head breather hose onto the air filter case,
making sure that the hose contacts the case.
N. Face the blue paint mark on the surge tank
hose downward.
O. Install the hose up to the bend in the hose
fitting.
P. Face the white paint mark on the surge tank
hose downward.
Q. Face the green paint mark on the intake
solenoid vacuum hose (intake solenoid to air
filter case valve) downward.
2-66
CABLE ROUTING