Yamaha 2014 MT-07 Service Manual page 63

4. Loosen and retighten the cylinder head bolts "1"–"6" to 20 Nm (2.0 m·kgf, 14 ft·lbf) in the proper tight-
ening sequence, and then tighten them further to reach the specified angle 90° in the proper tight-
ening sequence.
5. Tighten the cylinder head bolts "7" and "8" to 10 Nm (1.0 m·kgf, 7.2 ft·lbf).
TIP
Crankcase bolt
Tighten the crankcase bolts "1"–"27" in the proper tightening sequence as follows: Tighten the bolts "1"–
"16" in the order of the embossed numbers on the crankcase.
1. Lubricate the crankcase bolts "1"–"27" threads, mating surfaces, washers, and O-rings with the en-
gine oil.
2. Tighten the crankcase bolts "1"–"6" to 24 Nm (2.4 m·kgf, 17 ft·lbf).
3. Loosen and retighten the crankcase bolts "1"–"6" to 17 Nm (1.7 m·kgf, 12 ft·lbf) in the proper tight-
ening sequence, and then tighten them further to reach the specified angle 60° in the proper tight-
ening sequence.
4. Tighten the crankcase bolts "7"–"27".
"7"–"14": 24 Nm (2.4 m·kgf, 17 ft·lbf)
"15"–"16": 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
"17"–"27": 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tighten the bolts "17"–"27" in any tightening sequence using a crisscross pattern.
×2
×6 FWD
2
6
3
1
2-18
TIGHTENING TORQUES